OFP Forum, OFP Home, OFP File Formats, OFP Tools, OFP Missions, OFP 3D Modeling, OFP Terrain
Operation Flashpoint (OFP) aka ArmA: Cold War Assault (CWA)
I recommend using the component convex hull (CCH) function geo LODs - it's under the structure/convexity menu. Geo LODs require all the objects to have convex shapes (ie no concave angles to the faces) and for the objects to be named properly. This function does it all for you.
A simple example. If you make a L shaped block all in one piece, the 90 degree angle is concave so will not work. What you need to do is take the top part of the L and separate it from the lower part so that you have two square blocks, one sitting on top of the other. (note: you need to do this manually before you run the CCH function, if you do not, then it will join the top part with the lower right to make a convex shape.)
SelectThis
Invisible LODs for engine calculation. Textures are used for special surface characteristics.
Each Geometry LOD must contain named selections of all components. If there are any animated parts, they should keep the names as in other LODs. You can automatically select components by menu Structure→Topology→Find Components.
Geometry components must be closed convex objects
some help tools are in menu structure→convexity
Convexity→Find non-convex and “find non-convexities” - checking tools
Component Convex Hull will try to decompose object in convex components
Convex Hull makes one convex object
use Make convex and Convexity Fine Tune if previous tool fails (different algorithm)
Used for physical collision detection Must contain also information about object MASS (gray boxes) and center of gravity (blue cross).
The model should be very simple, defining the basic model shape. Thinner parts than 15cm cannot collide in faster speeds. Better if the geometry is larger than the model shape.
CTRL-A select all. Use MASS dialog to assign total mass. If you want to move the center of gravity, select vertices and change their individual mass. Keep an eye on the “total mass” check box.
It is not a problem, if some components do not have any mass. The mass of the whole model is used for collision, gravity and momentum. BUT, the component will not be simulated, if it has no named selection set.
1 mass = 1kg
Just like the gates / doors in the Resolution LODs, you have to make block/wall in the Geometry LOD similar to the door, and NAME them the same as your animated doors. This will animate the block/door in the Geometry LOD so your “invisible wall” opens as well.
In the Geometry LOD you have to use blocks/cubes to match your walls / floors / roof / doors. If you want open space inside the building, it must not filled inside with “blocks” except where walls are.
To make your Geometry LOD, I suggest;