arma:startup_parameters
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
arma:startup_parameters [2011-11-05 13:22] snakeman added new arma 2 parameters file descriptions. |
arma:startup_parameters [2011-11-06 16:50] snakeman added maxmem parameter. |
||
|---|---|---|---|
| Line 114: | Line 114: | ||
| The config file can be used to put startup parameters in, instead of specifying them at a shortcut / command line. | The config file can be used to put startup parameters in, instead of specifying them at a shortcut / command line. | ||
| - | NOTE: low level parameters are NOT supported. .par file does not (and will not) support some low level parameters, like: -cpuCount, -malloc and -exthreads. The reason is those need to be initialized before any file operations are done. | + | NOTE: low level parameters are NOT supported. .par file does not (and will not) support some low level parameters, like: -cpuCount, -malloc, -exthreads and -maxMem. The reason is those need to be initialized before any file operations are done. |
| Pre ArmA 2 build v1.59.**86060** | Pre ArmA 2 build v1.59.**86060** | ||
arma/startup_parameters.txt ยท Last modified: 2011-11-06 16:50 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
