PMC Editing Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== HOWTO Open ArmA 2 P3D Files ======

[[https://www.pmctactical.org/forum/viewforum.php?f=50|ArmA 2 Forum]], [[:arma2|ArmA 2 Home]], [[arma2:config|ArmA 2 Config]], [[arma2:file_formats|ArmA 2 File Formats]], [[arma2:missions|ArmA 2 Missions]], [[arma2:modeling|ArmA 2 3D Modeling]], [[arma2:scripting|ArmA 2 Scripting]], [[arma2:terrain|ArmA 2 Terrain]], [[arma2:texturing|ArmA 2 Texturing]], [[arma2:tools|ArmA 2 Tools]]

bis released P3D model files are ODOL format which is optimized MLOD (not decrypted, do not even say that) and cannot be opened with [[arma2:tools:oxygen2|O2]], you need to use one of these two following tools;

Mikero's [[arma2:tools:convertp3d|ConvertP3D]] which in fact while writing this page doesn't work that good.

T_D's [[arma2:tools:p3ddebinarizer|P3DDeBinarizer]] which works nicely.

Also [[arma2:tools:p3d_analyzer|P3D Analyzer]].

However before you use these tools on OA models, you need to hex edit the P3D's because their version number is higher than the tools are looking for. This is bit more complex but doable.

Open the P3D file in hex editor of your liking, you can see the ASCII part which says "ODOL2", scroll cursor to the ODOL**2** part and change that to 1, so the ASCII part would read then "ODOL1" instead. Save the P3D and then the current tools will open it fine.

Unfortunately at the time writing this page ConvertP3D or P3DDeBinarizer will NOT work on BAF and few selected OA (upgraded on v1.54 patch) P3D model files.