User Tools

Site Tools


arma3:port-arma2-howto-split-the-gear

This is an old revision of the document!


ArmA 2 Model Port - Splitting Up The Gear

PMCTODO - this page is work in progress ;)

This guide gives you the basics how to take your ArmA 2 porter character with all the helmet/gear equipment and split them up into individual parts like its done in ArmA 3.

Remove Helmet from your ArmA 2 ported character

Take your ArmA 2 ported character model that has a helmet, use Oxygen 2 to remove this helmet on all Resolution LODs and from ShadowVolume's etc. Make sure your character has correct ArmA 3 proxy's placed (in this case hmd proxy).

Inserting Helmet to your ArmA 2 ported character

This is done by a config, read details on ArmA 3 Custom Gear page how to setup helmet config.

Remove Vest from your ArmA 2 ported character

Take your ArmA 2 ported character model that has a vest, use Oxygen 2 to remove this vest from all Resolution LODs, ShadowVolume and View-Pilot. Make sure your character has correct ArmA 3 proxy's placed (in this case ? proxy).

Inserting Vest to your ArmA 2 ported character

This is done by a config, read details on ArmA 3 Custom Gear page how to setup vest config.

arma3/port-arma2-howto-split-the-gear.1407745958.txt.gz · Last modified: 2014/08/11 08:32 by snakeman

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki

All PMC web site download services are temporarily suspended until web site yearly fees have been recovered, want to download addons/mods? Then Support PMC.

If you are grateful for all the work PMC has done in the past 25 years, use Support PMC page.